Replacing a fuse box: warning signs, rules and cost
An old fuse box without an RCD? How to tell when your consumer unit needs replacing, what Swedish electrical rules require and what a replacement costs in the Gothenburg area.

A homeowner in Lindome called in November. The cooker hood tripped the fuse every time the oven was on, and he wanted a bigger fuse. What he got was an electrician who opened a fuse box from 1968, found a terminal screw that had turned brown from the heat, and switched off the mains before the quote had even been written.
That is no horror story. That is a Tuesday.
Short answer to the question in the title: the fuse box needs replacing when it has no residual current device (RCD), when it still has porcelain screw-in fuses, when fuses blow at regular intervals, or when something power-hungry is about to be installed in the house. Age in itself is not a fault. Age plus nobody having opened the door for thirty years is.
What the fuse box does
It distributes the building's electricity into circuits, and it cuts the power when something goes wrong. Two jobs.
The second is the important one, and it is exactly what old fuse boxes are bad at.
Eight signs the fuse box needs replacing
- Porcelain fuses. Ceramic screw-in fuses mean the fuse box is probably from the seventies or earlier, and almost certainly has no RCD.
- No RCD. Look for a button marked T or Test. If there isn't one, the installation has no protection for people.
- Fuses that blow repeatedly. A fuse that blows is a message, not a fault to be engineered away with a bigger fuse.
- Discolouration or smell. Brown marks around connections, a faint smell of warm Bakelite. Call the same day, not next week.
- Sockets that get warm or crackle when you pull out a plug.
- Mixed generations in the box. Four kinds of fuse and a handwritten note with the circuit list mean that many people have been there and nobody has had the full picture.
- The circuit list does not match, or does not exist at all.
- You are planning an EV charger, an air-to-water heat pump, solar panels or a new kitchen.
Each of the first three points is enough on its own.
The RCD is the whole point
A fuse protects the cable inside the wall. It does not care about you. It blows on overload and short circuit, which protects the house against fire, but the current through a human body is far too small for a ten-amp fuse to react to it.
The RCD (jordfelsbrytare) does the other half of the job. It compares the current going in with the current coming out and cuts the power within a fraction of a second if something is leaking out the wrong way, for example through you. The tripping level in homes is 30 milliamperes.
The requirement for RCDs in new residential installations came in around the turn of the millennium. If the house is older than that and the fuse box has never been upgraded, the protection simply is not there, and that is the strongest single reason to replace it.
What the rules require
Fixed electrical installations in Sweden must be carried out in accordance with the electrical installation standard SS 436 40 00. The work must be done by an electrical installation company registered with the Swedish National Electrical Safety Board (Elsäkerhetsverket) that has a self-inspection programme. That applies just as much in a house as in commercial premises or a cooperative apartment.
When replacing a fuse box, two further things normally apply:
- Advance and completion notifications to the grid company, if the meter board, the service cable or the main fuse is affected. The electrician handles it, but ask anyway to make sure it gets done.
- Surge protection, which is now part of a normal new fuse box and protects the building's electronics against transients from lightning and grid disturbances.
No building permit is needed, and no notification to the municipality either. Electrical work comes under the Electrical Safety Board, not the Planning and Building Act. It is one of the few things in the building trade where you avoid the municipality entirely.
What does it cost to replace a fuse box?
| Measure | Normal range | Comment |
|---|---|---|
| Adding an RCD to the existing fuse box | SEK 4,500–9,000 | Only works if the fuse box is otherwise sound |
| Replacing the fuse box, same number of circuits, house | SEK 18,000–30,000 | Including materials |
| Replacement with more circuits and a new meter board | SEK 30,000–55,000 | Most common in houses from before 1980 |
| EV charger with its own circuit and load balancing | SEK 15,000–28,000 | On top of any fuse box replacement |
The prices apply to the Gothenburg area and assume normal access. If the fuse box is built into a wardrobe or behind a panelled wall, building and painting work is needed afterwards, and that is the item people forget.
The ROT tax deduction covers 30 per cent of the labour cost, up to the annual cap per person. Materials are not included. We always split the items in the quote, just as for a bathroom renovation and other work that qualifies for ROT.
How the replacement works
- Walkthrough on site. We look at the existing fuse box, service cable, meter position and earthing, and size the circuits against actual need rather than against whatever happens to be there.
- Quote and advance notification. A fixed price, and notification to the grid owner where required.
- Replacement day. The mains is switched off, the old fuse box is removed, the new one is fitted and the circuits are connected one by one. The power is off for four to eight hours. The fridge and freezer will be fine, but keep the doors closed all day.
- Testing and measurement. Insulation resistance testing, checking the RCD's tripping time and a function test on every circuit.
- Documentation. A new circuit list in the fuse box, and the test report and self-inspection record for you.
A normal house replacement takes one working day. If the meter board needs moving or the service cable replacing, it takes two days, and then it is the grid owner's schedule that sets the calendar, not ours.
An EV charger, heat pump or solar panels change the equation
This is the most common reason anyone calls us about a fuse box in the first place.
An EV charger must have its own circuit and fault protection that can handle DC faults. Many older fuse boxes simply do not have room, and just as often the main fuse is not enough when charging, the heat pump and cooking all coincide on a Tuesday in January. The solution is rarely a bigger main fuse, which raises the grid fee every month for ever. The solution is load balancing, which lets the charger back off when the house needs the power elsewhere.
If you are going to do any of this anyway: do the fuse box at the same time. Same trip, same set-up, and the price difference is smaller than you think.
Check the company before you let anyone in
The Electrical Safety Board has an open e-service, Kolla elföretaget ("Check the electrical company"), where you search by company name or corporate identity number and see whether the company is registered for exactly the type of work you intend to order. It takes half a minute and there is no excuse for skipping it.
Also ask for:
- Confirmation of what type of work the registration covers
- A self-inspection record and circuit list at handover
- A fixed price, with written terms for whatever may turn up behind the old fuse box
If you get evasive answers to the first point, the conversation is over.
Cooperative apartment or rental building: who owns the fuse box?
In a cooperative apartment the boundary normally lies at the apartment's fuse box. The stacks and main cables belong to the cooperative; the fuse box and everything after it is usually the member's maintenance responsibility.
Usually. The statutes decide, and they differ more than people think. Read them before you order, not afterwards.
For cooperatives and property owners, the fuse boxes belong in the maintenance plan together with the roof and the stacks. A round of thermal imaging every five years finds overheating connections while they are still only warm, and it costs about as much as the pure administration of an insurance investigation.
Frequently asked questions
How long is the power off during a replacement?
Four to eight hours for a normal house. If the meter board or service cable is also replaced it can take longer, and the grid owner's schedule decides.
Do I have to replace the whole fuse box or is an RCD enough?
If the fuse box is otherwise sound, it can be upgraded. If it is from the screw-in fuse generation, it is usually money wasted, because the terminals, enclosure and wiring are then as old as everything else in the box.
How often should an electrical installation be checked?
For a house, a visual check of the fuse box every year and an electrical inspection every ten years is a reasonable pace. Apartment buildings and commercial premises need shorter intervals, and there thermal imaging is a much better tool than the eye.
Can I replace the fuse box myself?
No. Work on fixed installations may only be carried out by an electrical installation company registered with the Electrical Safety Board. DIY work in the fuse box can also affect your home insurance payout in the event of a fire.
What does an electrical inspection of a house cost?
Expect SEK 4,000 to 8,000 for a visual inspection with a report. If thermal imaging is included, it costs more. It is cheap insurance if you have bought a house where you don't know who has done what.
Need an electrician in the Gothenburg area?
Byggentra AB carries out electrical installations and fuse box replacements in Kållered, Mölndal, Gothenburg, Lindome, Kungsbacka, Landvetter and Partille, for homeowners, housing cooperatives and businesses. If you are renovating at the same time, we handle electrics, plumbing and building work in the same project, so you don't have to act as project coordinator in your spare time.
Describe the job and we'll get back to you with a free quote within 24 hours on weekdays.



